Titebond Adhesive Remover Cleaning Wipes are formulated to remove a variety of adhesive and sealant technologies including solvent-based, advanced polymer, urethane, water-based and polyvinyl acetate (PVA) adhesives. The wipes can be used for clean up on a variety of different surfaces and applications, including most pre-finished (non-waxed) flooring surfaces and tools. It is important to use Titebond Adhesive Remover Cleaning Wipes while you work and within 24 hours of adhesive application. NOTE: Wipes perform best when the adhesive is still in the wet state.

Features & Benefits

  • Easy-to-use wipes
  • Pre-soaked towels
  • Removes many adhesive types
  • Powerful organic formula

Application Guidelines

  • For Use as a Urethane Release Agent: Wipe finished surface (top) of each board with Titebond Adhesive Remover wipes prior to spreading urethane glues to ensure easy clean-up of urethane adhesives on finished wood floors. Be sure to thoroughly wash the newly installed floor once installation is complete to remove remaining adhesive remover. CAUTION: Floor will be extremely slippery with remover residue on the wood surface
  • For General Adhesive Removal:
    1. Pull off container cover and remove and discard seal. From the center of the roll, pull up a corner of a wipe, twist to a point and thread through the hole in the underside of the cover. Replace cover tightly. Pull towel through dispensing hole and tear at perforation. Close snap-down lid to keep towels from drying out when not in use.
    2. Rub area of floor that has wet or cured adhesive with a cleaning wipe in a slow circular manner. See “USER TIPS” on label for more information.
    3. If adhesive has cured for more than 48 hours, lay a towel over the cured adhesive and let stand for approximately five minutes. Wipe area clean with a fresh towel to remove excess adhesive and repeat.
    4. Once you have cleaned the affected area with a cleaning wipe, wipe the area with a clean, water-dampened cloth to remove any remaining remover.
  • Note: If you are cleaning a floor surface, clean the affected area with a cleaning wipe; wipe the area with a clean cloth and a pre-finished floor cleaner to completely remove any oily residue and to prevent slipping.

Physical Properties

  • Color: Translucent
  • Calculated VOC: 14 g/L
  • Odor: Citrus odor
  • Flashpoint: 200°F (94°C)


Be sure NOT to scrub the surface too aggressively as this will change the look of the finish, particularly with floors. Do NOT allow excess remover to drop between floor boards. Close cap when wipes are not in use. Store this product in a clean, dry area. For additional questions or recommendations, please contact Technical Service at 1.800.347.4583 or visit us at Titebond.com.

Product SKUs

Part NumberUPCCase UPCSizeWeightUnits Per PackagePackages Per Pallet
1630003708316300110037083163008Canister (60 Wipes)4.606120

Caution Statement

CAUTION: WARNING. Causes skin and serious eye irritation. Wear eye protection, protective clothing, protective gloves. Wash hands thoroughly after handling. FIRST AID: Never give anything by mouth to an unconscious person. If you feel unwell, seek medical advice (show the label where possible). IF INHALED: Remove to fresh air and keep at rest in a position comfortable for breathing. Call a POISON CENTER or doctor/physician if unwell. IF ON SKIN: Immediately rinse with plenty of soap and water (for at least 15 minutes). Take off contaminated clothing and wash before reuse. If irritation persists: Get medical advice/attention. IF IN EYES: Rinse immediately and thoroughly, pulling the eyelids well away from the eye (15 minutes minimum). Remove contact lenses if present and easy to do so. If eye irritation persists: Get medical advice/attention. IF SWALLOWED: Rinse mouth, Do NOT induce vomiting, Obtain emergency medical attention.

Dispose of contents/container to licensed waste handling facility. For additional information, refer to Safety Data Sheet.

Important Notice: Our recommendations, if any, for the use of this product are based on tests believed to be reliable. Since the use of this product is beyond the control of the manufacturer, no guarantee or warranty, expressed or implied, is made as to such use or effects incidental to such use, handling or possession or the results to be obtained, whether in accordance with the directions or claimed so to be. The manufacturer expressly disclaims responsibility therefore. Furthermore, nothing contained herein shall be construed as a recommendation to use any product in conflict with existing laws and/or patents covering any material or use.

2020 Bruck Street, Columbus, Ohio 43207
CUSTOMER SERVICE 1-800-669-4583
TECH SERVICE 1-800-347-4583

Franklin International